安裝要則
- 發布日期:2009-04-24 10:18:49
- 閱讀數:8988
安裝要則Installs the important regulation
●檀條可選用管鋼（60x40X3mm）或C型鋼（100X50x20X3mm）或木方（60X40mm），要做防腐處理。
●檀條間距為660mm，由下往上排布。
●主瓦安裝時要根據當地風向，逆向安裝，搭接一個瓦波，兩側同時進行。
●安裝正脊瓦時將**張脊瓦截掉一段后再安裝。
● The strip may ｓｅｌｅｃｔ the tube steel （60x40x3mm） either the c section （100x50x20x3mm） or the wooden side （60x40mm）， must make the antiseptic treatment.
●The strip spacing is 660mm, upward distributes by under.
●The main tile installs when must act according to the local wind direction， the reversion installment， joins a tile wave， two sides also carry on.
●Installs after when the ridge tile falls the first ridge tile truncation a section to install again.
●Slanting ridge tile installment joining place should saw neat，after ，the slanting ridge tile attire finished， then installs the three contacts tile.
●Fixed is the stainless steel component. When fixed， first uses the electric drill dill hole， the aperture to have nail lead screw to be bigger than 2mm.